• BS EN 55020:2007+A12:2016

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    Sound and television broadcast receivers and associated equipment. Immunity characteristics. Limits and methods of measurement

    Available format(s):  Hardcopy, PDF

    Superseded date:  01-01-2017

    Language(s):  English

    Published date:  29-02-2016

    Publisher:  British Standards Institution

    Add To Cart

    Abstract - (Show below) - (Hide below)

    This standard for immunity requirements applies to television broadcast receivers, sound broadcast receivers and associated equipment intended for use in the residential, commercial and light industrial environment.

    Scope - (Show below) - (Hide below)

    This standard for immunity requirements applies to television broadcast receivers, sound broadcast receivers and associated equipment intended for use in the residential, commercial and light industrial environment.

    This standard describes the methods of measurement and specified limits applicable to sound and television receivers and to associated equipment with regard to their immunity characteristics to disturbing signals.

    This standard is also applicable to the immunity of outdoor units of direct to home (DTH) satellite receiving systems for individual reception.

    NOTE 1 Receiving systems for collective reception, in particular cable distribution head ends (Community Antenna Television, CATV) and community reception systems (Master Antenna Television, MATV) are covered by IEC 60728-2.

    NOTE 2 Broadcast receivers for digital signals are covered by Annex I and Annex J.

    Immunity requirements are given in the frequency range 0 Hz to 400 GHz. Radio-frequency tests outside the specified frequency bands or concerning other phenomena than given in this standard are not required.

    The objective of this standard is to define the immunity test requirements for equipment defined in the scope in relation to continuous and transient, conducted and radiated disturbances including electrostatic discharges.

    These test requirements represent essential electromagnetic immunity requirements.

    Test requirements are specified for each port (enclosure or connector) considered.

    NOTE 3 This standard does not specify electrical safety requirements for equipment such as protection against electric shocks, unsafe operation, insulation co-ordination and related dielectric tests.

    NOTE 4 In special cases, situations will arise where the level of disturbances may exceed the levels specified in this standard e.g. where a hand-held transmitter is used in proximity to an equipment. In these instances special mitigation measures may have to be employed.

    The environments encompassed by this standard are residential, commercial and light-industrial locations, both indoor and outdoor. The following list, although not comprehensive, gives an indication of locations which are included:

    • residential properties, e.g. houses, apartments, etc.;

    • retail outlets, e.g. shops, supermarkets, etc.;

    • business premises, e.g. offices, banks, etc.;

    • areas of public entertainment, e.g. cinemas, public bars, dance halls, etc.;

    • outdoor locations, e.g. petrol stations, car parks, amusement and sports centres, etc.;

    • light-industrial locations e.g. workshops, laboratories, service centres, etc.;

    • car and boat.

    Locations which are characterized by their mains power being supplied directly at low voltage from the public mains are considered to be residential, commercial or light industrial.

    General Product Information - (Show below) - (Hide below)

    Committee GEL/210
    Document Type Standard
    Product Note This standard also refers to EN 55016-1-3:2006, EN 61000-4-2:1995,EN 61000-4-3:2006,EN 61000-4-4:2004, EN 61672-1:2003, ITU-R BS 468-4, ITU-R BT.471-1:1986, ITU-R BT.500-10, CISPR 16-4-3,EN 55022:2006, EN 55024:1998.
    Implementation of CENELEC amendment A12:2016
    Publisher British Standards Institution
    Status Superseded
    Supersedes
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective