BS EN 60095-1 : 93 AMD 11016

Cooperating organizations
National foreword
Foreword
SECTION ONE - GENERAL
1.1 Scope
1.2 Object
1.3 Electrolyte density and open circuit voltage
1.4 Condition on delivery
SECTION TWO - GENERAL REQUIREMENTS
2.1 Identification, labelling
2.2 Marking of the polarity
2.3 Additional designation
2.4 Not used
SECTION THREE - FUNCTIONAL CHARACTERISTICS
3.1 Electrical characteristics
3.2 Mechanical characteristics
SECTION FOUR - GENERAL TEST CONDITIONS
4.1 Sampling of batteries
4.2 Preparation of batteries prior to test - Definition
       of a fully-charged battery
4.3 Activation of dry-charged batteries
4.4 Measuring instruments
4.5 Test sequence
SECTION FIVE - TESTS/METHODS AND REQUIREMENTS
5.1 Capacity check Ceard with the references of the
       relevant European publications
5.2 Reserve capacity check Cr,e
5.3 Cranking performance test
5.4 Charge acceptance test
5.5 Charge retention test
5.6 Endurance test
5.7 Not used
5.8 Water consumption test
5.9 Vibration resistance test
5.10 Electrolyte retention test
5.11 Cranking performance for dry-charged batteries after
       activation
Appendix A - Correlation of Cn and Cr,n
Annex ZA (normative) Other international publications quoted
                     in this standard with the references of
                     the relevant European publications
Annex ZB (normative) European type number for starter
                     batteries
Annex ZC (normative) Indications regarding EC directives
National Annex NA (informative) Committees responsible

Defines the use of lead-acid batteries with a nominal voltage of 12 V, used primarily as a power source for the starting of internal combustion engines, lighting and also for auxiliary equipment of internal combustion engine vehicles. Commonly known as "starter batteries", with a nominal voltage of 6 V are also included for; passenger cars, for commercial and industrial vehicles for normal use, and severe use. Not applicable to batteries for other purposes, e.g. the starting of railcar internal combustion engines.