BS EN 60317-56:2017

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions, general notes and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion (for nominal diameters
   of 0,250 mm up to and including 0,900 mm)
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin-hole test
30 Packaging
Annex A (informative) - Resistance to abrasion
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Defines the requirements of solderable fully insulated (FIW) zero-defect enamelled round copper wire, class 180, with a single coating based on polyurethane resin, which may be modified providing it retains its chemical identity and satisfies all the required technical specifications.

This part of IEC 60317 specifies the requirements of solderable fully insulated (FIW) zero-defect enamelled round copper wire, class 180, with a single coating based on polyurethane resin, which may be modified providing it retains its chemical identity and satisfies all the required technical specifications.

The range of nominal conductor diameters of the wires covered by this standard is as follows:

• Grade of FIW 4, 6, 8: 0,090 mm up to and including 0,900 mm.

Nominal conductor diameters are specified in IEC 60317-0-7–.