BS EN 60317-61:2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Specifications for particular types of winding wires Polyester glass fibre wound, minimum class 180, resin or varnish impregnated, bare or enamelled rectangular copper wire, temperature index 180
Hardcopy , PDF
01-07-2020
English
30-09-2012
Important note : Users cannot be edited or removed once added to your Multi user PDF.
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and general notes and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
23 Pin hole test
30 Packaging
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Defines the requirements of polyester glass fibre wound, impregnated, bare or enamelled rectangular copper winding wire, temperature index 180.
| Committee |
W/-
|
| DevelopmentNote |
Supersedes 10/30206053 DC. (09/2012)
|
| DocumentType |
Standard
|
| Pages |
14
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of IEC 60317 specifies the requirements of polyester glass fibre wound, impregnated, bare or enamelled rectangular copper winding wire, temperature index 180.
NOTE For this type of wire, the heat shock test is inappropriate and therefore a heat shock temperature cannot be established. Consequently, a class based on the requirements for temperature index and heat shock temperature cannot be specified.
The range of nominal conductor dimensions covered by this standard is:
| – | width: | min. 2,0 mm; | max. 16,0 mm; |
| – | thickness: | min. 0,80 mm; | max. 5,60 mm. |
The specified combinations of width and thickness as well as the specified width/thickness ratio are according to IEC 60317-0-8.
| Standards | Relationship |
| EN 60317-61 : 2012 | Identical |
| IEC 60317-61:2012 | Identical |
| IEC 60317-0-8:2012 | Specifications for particular types of winding wires - Part 0-8: General requirements - Polyester glass fibre wound, resin or varnish impregnated or not impregnated, bare or enamelled rectangular copper wire |
| EN 60317-0-8 : 2012 | SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-8: GENERAL REQUIREMENTS - POLYESTER GLASS FIBRE WOUND, RESIN OR VARNISH IMPREGNATED OR NOT IMPREGNATED, BARE OR ENAMELLED RECTANGULAR COPPER WIRE (IEC 60317-0-8:2012) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.