BS EN 60384-6:2005

FOREWORD
1 General
  1.1 Scope
  1.2 Normative references
  1.3 Information to be given in a detail specification
  1.4 Terms and definitions
  1.5 Marking
2 Preferred ratings and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Certified records of released lots
  3.4 Qualification approval
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Visual examination and check of dimensions
  4.2 Electrical tests
  4.3 Robustness of terminations
  4.4 Resistance to soldering heat
  4.5 Solderability
  4.6 Rapid change of temperature
  4.7 Vibration
  4.8 Bump
  4.9 Shock
  4.10 Climatic sequence
  4.11 Damp heat, steady state
  4.12 Endurance
  4.13 Charge and discharge
  4.14 Component solvent resistance
  4.15 Solvent resistance of the marking
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Applicable to fixed capacitors for direct current with metallized electrodes and polycarbonate dielectric for use in electronic equipment.

applies to fixed capacitors for direct current with metallized electrodes and polycarbonate dielectric for use in electronic equipment.Two performance grades of capacitors are covered, Grade 1 for long life application and Grade 2 for general application