BS EN 60684-3-100 to 105:2002

Foreword
INTRODUCTION
1 Scope
2 Normative references
3 Designation
4 Requirements
5 Product qualification
Table 1 - Dimensions - Sheets 100 and 101
Table 2 - Dimensions - Sheets 102
Table 3 - Dimensions - Sheets 103 and 104
Table 4 - Dimensions - Sheet 105
Table 5 - Property requirements
Table 6 - Additional property requirements
Table 7 - Mandrel diameters for low temperature bend test
Table 8 - Requirements for breakdown voltage
Annex ZA (normative) Normative references to international
          publications with their corresponding European
          publications

Gives the requirements for three types of non-heatshrinkable sleeving, extruded from PVC. Sleeving of this type is normally available with an internal diameter up to 50 mm and in a range of wall thickness between 0,2 mm and 1,8 mm.

Gives the requirements for three types of non-heatshrinkable sleeving, extruded from PVC. Sleeving of this type is normally available with an internal diameter up to 50 mm and in a range of wall thicknesses between 0,2 mm and 1,8 mm. Each sheet covers up to three levels of wall thickness, \'thin wall\', \'standard wall\' and \'thick wall\' related to nominal internal diameter and with corresponding differences in requirements for breakdown voltage. Sheets 100 and 103 cover sleeving having a temperature range of -10 °C to 90 °C. Sheets 101 and 104 cover sleeving having a temperature range of -10 °C to 105 °C. Sheets 102 and 105 cover sleeving having a temperature range of -40 °C to 70 °C.