BS EN 60938-2:2000

FOREWORD
1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a detail specification
  1.5 Definitions
  1.6 Marking
2 Preferred ratings and characteristics
  2.1 Climatic categories
  2.2 Values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar inductors
  3.3 Certified records of released lots
  3.4 Qualification approval
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Visual examination and check of dimensions
  4.2 Voltage proof
  4.3 Insulation resistance
  4.4 Inductance
  4.5 DC line resistance
  4.6 Robustness of terminations
  4.7 Resistance to soldering heat
  4.8 Solderability
  4.9 Rapid change of temperature
  4.10 Vibration
  4.11 Bump
  4.12 Shock
  4.13 Container sealing
  4.14 Climatic sequence
  4.15 Damp heat, steady state
  4.16 Temperature rise (applies only to inductors with
       a mass > 5 g)
  4.17 Impulse voltage (applies to inductors with more
       than one winding)
  4.18 Endurance
  4.19 Passive flammability (if applicable)
  4.20 Component solvent resistance (if applicable)
  4.21 Solvent resistance of marking (if applicable)
Annex A (normative) Test schedule for safety tests only
                    approval
Annex B (normative) Test schedule for safety tests and
                    performance tests for qualification
                    approval, assessment level D
Annex C (normative) Example of a suitable circuit for the
                    endurance test voltage
Annex D (normative) Declaration of design (confidential to the
                    manufacturer and the certification body)
Annex E (normative) Test methods for thyristor electromagnetic
                    interference suppression inductors
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications

Applicable to fixed inductors intended for electromagnetic interference suppression which come in the scope of the generic specification IEC 60938-1. Applies only to fixed inductors where safety tests are appropriate.