BS EN 61000-4-6:2014

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Test levels
6 Test equipment and level adjustment
   procedures
7 Test setup and injection methods
8 Test procedure
9 Evaluation of the test results
10 Test report
Annex A (normative) - EM and decoupling clamps
Annex B (informative) - Selection criteria for the
        frequency range of application
Annex C (informative) - Guide for selecting test levels
Annex D (informative) - Information on coupling and
        decoupling networks
Annex E (informative) - Information for the test
        generator specification
Annex F (informative) - Test setup for large EUTs
Annex G (informative) - Measurement uncertainty of the
        voltage test level
Annex H (informative) - Measurement of AE impedance
Annex I (informative) - Port to port injection
Annex J (informative) - Amplifier compression and
        non-linearity
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Describes a common reference for evaluating the functional immunity of electrical and electronic equipment when subjected to conducted disturbances induced by RF fields.

IEC 61000-4-6:2013 relates to the conducted immunity requirements of electrical and electronic equipment to electromagnetic disturbances coming from intended radio-frequency (RF) transmitters in the frequency range 150 kHz up to 80 MHz. Equipment not having at least one conducting wire and/or cable (such as mains supply, signal line or earth connection) which can couple the equipment to the disturbing RF fields is excluded from the scope of this publication. The object of this standard is to establish a common reference for evaluating the functional immunity of electrical and electronic equipment when subjected to conducted disturbances induced by RF fields. The test method documented in IEC 61000-4-6:2013 describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon. This fourth edition cancels and replaces the third edition published in 2008 and constitutes a technical revision. It includes the following significant technical changes with respect to the previous edition:
- use of the CDNs;
- calibration of the clamps;
- reorganization of Clause 7 on test setup and injection methods;
- Annex A which is now dedicated to EM and decoupling clamps;
- Annex G which now addresses the measurement uncertainty of the voltage test level;
- and informative Annexes H, I and J which are new. The contents of the corrigendum of June 2015 have been included in this copy.