BS EN 61010-2-030:2010

1 Scope and object
2 Normative references
3 Terms and definitions
4 Tests
5 Marking and documentation
6 Protection against electric shock
7 Protection against mechanical HAZARDS
8 Resistance to mechanical stresses
9 Protection against the spread of fire
10 Equipment temperature limits and resistance to heat
11 Protection against HAZARDS from fluids
12 Protection against radiation, including laser sources,
   and against sonic and ultrasonic pressure
13 Protection against liberated gases and substances,
   explosion and implosion
14 Components and subassemblies
15 Protection by interlocks
16 HAZARDS resulting from application
17 RISK assessment
101 Measuring circuits
Annexes
Annex K (normative) - Insulation requirements not covered
        by 6.7
Annex L (informative) - Index of defined terms
Annex AA (normative) - Measurement categories
Annex BB (informative) - Hazards pertaining to measurements
         performed in certain environments
Bibliography

Defines safety requirements for testing and measuring circuits which are connected for test or measurement purposes to devices or circuits outside the measurement equipment itself.

This clause of Part1 is applicable except as follows: 1.1.1 Equipment included in scope Replace the text with the following: This part of IEC61010 specifies safety requirements for testing and measuring circuits which are connected for test or measurement purposes to devices or circuits outside the measurement equipment itself. These include measurement circuits which are part of electrical test and measurement equipment, laboratory equipment, or process control equipment. The existence of these circuits in equipment requires additional protective means between the circuit and an operator. NOTE1 These testing and measuring circuits may, for example: measure voltages in circuits of other equipment,measure temperature of a separate device via a thermocouple,measure force on a separate device via a strain gauge,inject a voltage onto a circuit to analyze a new design. NOTE2 Testing and measuring circuits that are not within the scope of this Part2 are considered to be covered by the requirements of Part1. NOTE3 Equipment containing these testing and measuring circuits may be intended for performing tests and measurements on hazardous conductors, including mains conductors and telecommunication network conductors. See AnnexBB for considerations of hazards involved in various tests and measurements.