BS EN 61215-1-4:2017

FOREWORD
1 Scope and object
2 Normative references
3 Terms and definitions
4 Test samples
5 Marking and documentation
6 Testing
7 Pass criteria
8 Major visual defects
9 Report
10 Modifications
11 Test flow and procedures
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Defines requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 60721-2-1.

This part of IEC61215 lays down IEC requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC60721‑2‑1 . This document is intended to apply to all thin-film Cu(In,Ga)(S,Se) 2 based terrestrial flat plate modules. As such it addresses special requirements for testing of this technology supplementing IEC61215‑1:2016 and IEC61215‑2:2016 requirements for testing. This document does not apply to modules used with concentrated sunlight although it may be utilized for low concentrator modules (1 to 3 suns). For low concentration modules, all tests are performed using the current, voltage and power levels expected at the design concentration. The object of this test sequence is to determine the electrical and thermal characteristics of the module and to show, as far as possible within reasonable constraints of cost and time, that the module is capable of withstanding prolonged exposure in climates described in the scope. The actual lifetime expectancy of modules so qualified will depend on their design, their environment and the conditions under which they are operated. This document defines PV technology dependent modifications to the testing procedures and requirements per IEC61215‑1:2016 and IEC61215‑2:2016 .