• There are no items in your cart

BS EN 62196-2:2017

Withdrawn

Withdrawn

A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.

View Superseded by

Plugs, socket-outlets, vehicle connectors and vehicle inlets. Conductive charging of electric vehicles Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories

Available format(s)

Hardcopy , PDF

Withdrawn date

20-12-2022

Superseded by

BS EN IEC 62196-2:2022

Language(s)

English

Published date

24-05-2017

€303.84
Excluding VAT

Committee
PEL/23
DevelopmentNote
Supersedes 10/30216167 DC. (06/2012) 2012 Edition along with its corrigendum remains active and will be withdrawn on 15/10/2017. (06/2013) 2012 + A11 2013 Edition remains active & will be withdrawn on 16/06/2017. Supersedes 13/30295018 DC. (09/2014) Supersedes 14/30311590 DC. (05/2017)
DocumentType
Standard
Pages
68
PublisherName
British Standards Institution
Status
Withdrawn
SupersededBy
Supersedes

This part of IEC62196 applies to plugs, socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardized configurations, herein referred to as accessories. They have a nominal rated operating voltage not exceeding 480V a.c., 50Hz to 60Hz, and a rated current not exceeding 63A three-phase or 70A single phase, for use in conductive charging of electric vehicles. This part of IEC62196 covers the basic interface accessories for vehicle supply as specified in IEC62196‑1 , and intended for use in conductive charging systems for circuits specified in IEC61851‑1:2010 . NOTE1 Electric road vehicles (EV) implies all road vehicles, including plug-in hybrid road vehicles (PHEV), that derive all or part of their energy from RESS. These accessories are intended to be used for circuits specified in IEC61851‑1:2010 which operate at different voltages and frequencies and which may include extra-low voltage (ELV) and communication signals. These accessories may be used for bidirectional power transfer (under consideration). This standard applies to accessories to be used in an ambient temperature between –30°C and +50°C. NOTE2 In the following country, other requirements regarding the lower temperature may apply: NO. NOTE3 In the following country, –35°C applies: SE. These accessories are intended to be connected only to cables with copper or copper-alloy conductors. Vehicle inlet and vehicle connector to this standard are intended to be used for charging in modes 1, 2 and 3, cases B and C. The socket-outlets and plugs covered by this standard are intended to be used for charging mode 3 only, case A and B. The modes and permissible connections are specified in IEC62196‑1:2014 .

Standards Relationship
IEC 62196-2:2016 Identical
EN 62196-2:2017 Identical

BS 7671(2008) : 2018 REQUIREMENTS FOR ELECTRICAL INSTALLATIONS - IET WIRING REGULATIONS
BS 7671(2008) : 2008 REQUIREMENTS FOR ELECTRICAL INSTALLATIONS - IET WIRING REGULATIONS

EN 62196-1:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements
IEC 62196-1:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.