BS EN 62488-2:2017

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
4 Low frequency side interfaces
5 Transmission line side high frequency interface
6 Quality and Performance
7 Testing
8 Configuration and management
9 Cyber security
10 APLC safety
11 Storage and transportation, operating
   conditions, power supply
12 EMC
Annex A (normative) - Characteristics of compandors
        for telephony (based on the withdrawn ITU-T
        Recommendation G.162)
Annex B (informative) - APLC communication model
Annex C (informative) - HF modulated power signal
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Pertains to Amplitude Modulation Single Sideband (AM-SSB) Analogue Power Line Carrier (APLC) Terminals and Systems used to transmit information over power lines (EHV/HV/MV).

This part of IEC 62488 applies to Amplitude Modulation Single Sideband (AM-SSB) Analogue Power Line Carrier (APLC) Terminals and Systems used to transmit information over power lines (EHV/HV/MV).

In particular this document covers basically baseband signals with bandwidths of 4 kHz and 2,5 kHz, or multiples thereof, corresponding to the same high frequency bandwidth/s for single or multi-channel APLC terminals.

Figure 1 shows a schematic representation of the scope of the IEC 62488-2 standard within a complete power line communication system installation.