BS EN 62733:2015

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Risk assessment
6 Requirements for abnormal operating
  and fault conditions
7 Requirements for software
8 Requirements for EMC immunity
Annex A (normative) - Software evaluation
Annex B (informative) - FTA and FMEA analysis
Annex C (informative) - Guidance on the identification
        of a protective programmable component
Annex D (normative) - Risk classification
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding
         European publications

Defines general and safety requirements for programmable components used in products covered by IEC 61347.

This International Standard provides general and safety requirements for programmable components used in products covered by IEC61347 . The requirements of this standard are only applicable to the programmable components (including its embedded software) in the electronic lamp controlgear. For other electric/electronic circuits and their components in the electronic lamp controlgear, the requirements of IEC61347 series apply.