BS EN 62841-3-9:2015

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General conditions for the tests
6 Radiation, toxicity and similar hazards
7 Classification
8 Marking and instructions
9 Protection against access to live parts
10 Starting
11 Input and current
12 Heating
13 Resistance to heat and fire
14 Moisture resistance
15 Resistance to rusting
16 Overload protection of transformers and
   associated circuits
17 Endurance
18 Abnormal operation
19 Mechanical hazards
20 Mechanical strength
21 Construction
22 Internal wiring
23 Components
24 Supply connection and external flexible cables and cords
25 Terminals for external conductors
26 Provision for earthing
27 Screws and connections
28 Creepage distances, clearances and distances through
   insulation
Annex I (normative) - Measurement of noise and vibration
        emissions
Annex K (normative) - Battery tools and battery packs
Annex L (normative) - Battery tools and battery packs
        provided with mains connection or non-isolated sources
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZ (informative) - Coverage of Essential
         Requirements of Directive 2006/42/EC

Pertains to transportable mitre saws intended to be used with a toothed saw blade for cutting wood and analogous materials, plastics and nonferrous metals except magnesium with a saw blade diameter not exceeding 360 mm, which hereinafter might simply be referred to as saw or tool.

This clause of Part1 is applicable, except as follows: Addition: This part of IEC62841 applies to transportable mitre saws intended to be used with a toothed saw blade for cutting wood and analogous materials, plastics and nonferrous metals except magnesium with a saw blade diameter not exceeding 360mm, which hereinafter might simply be referred to as saw or tool. This standard applies to mitre saws having a mass of: maximum 25kg for tools capable of being lifted by hand by one person; maximum 50kg for tools capable of being lifted by hand by two persons. This standard does not apply to stationary mitre saws. NOTE EN1870‑3 gives requirements for stationary mitre saws and mitre saws with a mass greater than indicated above. This standard does not apply to mitre saws intended to cut other metals, such as magnesium, steel and iron. This standard does not apply to mitre saws with an automatic feeding device. NOTE101 Transportable saws intended to cut ferrous metals will be covered by a future part of IEC62841‑3 . This standard does not apply to saws designed for use with abrasive wheels. NOTE102 Transportable tools designed for use with abrasive wheels are covered by IEC62841‑3‑10 . This standard does not apply to tools combining the function of a mitre saw with the function of a table saw. NOTE103 Transportable tools combining the function of a mitre saw with the function of a table saw are covered by IEC62841‑3‑11 .