BS EN 752-3:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Drain and sewer systems outside buildings Planning
Hardcopy , PDF
English
15-01-2001
30-04-2008
Committees responsible
National foreword
Foreword
1 Scope
2 Normative references
3 Definitions
4 Sources of additional information
5 General
6 Sewer systems
7 Permissible utilization
8 Layout
9 Overflows and surface water treatment
10 Ventilation of drains and sewers
11 Disused drains and sewers
12 Local treatment
13 Long sea outfalls
Annex A (informative) Sources of additional information
National Annex NA (informative) Materials selection
National Annex NB (informative) Access to drains and sewers
Table NA.1 - Materials and products commonly used in sewerage
construction
Table NB.1 - Maximum spacing of access provision
Table NB.2 - Minimum dimensions for rodding eyes, access
fittings, inspection chambers and manholes
Applies to drain and sewer systems operating under gravity, from the point where sewage leaves a building or roof drainage system, or enters a road gully to its discharge point at a treatment works or receiving water. Includes drains and sewers below buildings if they are not part of that building's drainage system.
| Committee |
B/505
|
| DevelopmentNote |
Supersedes 92/14708 DC, 95/105617 DC and BS 8005-1(1987) Supersedes 98/107256 DC (05/2005) Partially supersedes BS 8301(1985). (11/2005)
|
| DocumentType |
Standard
|
| Pages |
34
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| NF EN 752-3 : 1996 | Identical |
| NS EN 752-3 : 1ED 1996 | Identical |
| EN 752-3 : 1996 | Identical |
| I.S. EN 752-3:1997 | Identical |
| NEN EN 752-3 : 1996 | Identical |
| NBN EN 752-3 : 1996 | Identical |
| DIN EN 752-3:1996-09 | Identical |
| UNE-EN 752-3:1997 | Identical |
| BS 6465-3:2006 | Sanitary installations Code of practice for the selection, installation and maintenance of sanitary and associated appliances |
| BS 6465-1(2006) : 2006 | SANITARY INSTALLATIONS - PART 1: CODE OF PRACTICE FOR THE DESIGN OF SANITARY FACILITIES AND SCALES OF PROVISION OF SANITARY AND ASSOCIATED APPLIANCES |
| BS 5911-3:2002 | Concrete pipes and ancillary concrete products Specification for unreinforced and reinforced concrete manholes and soakaways (complementary to BS EN 1917:2002) |
| BS 5911-200:1994 | Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced manholes and soakaways of circular cross section |
| BS 7158:2001 | Plastics inspection chambers for drains and sewers. Specification |
| BS 5502-25:1991 | Buildings and structures for agriculture Code of practice for design and installation of services and facilities |
| BS 4660:2000 | Thermoplastics ancillary fittings of nominal sizes 110 and 160 for below ground gravity drainage and sewerage |
| BS 8005-0:1987 | Sewerage Introduction and guide to data sources and documentation |
| BS 8000-14:1989 | Workmanship on building sites Code of practice for below ground drainage |
| BS 8301:1985 | Code of practice for building drainage |
| BS 8005-2:1987 | Sewerage Guide to pumping stations and pumping mains |
| EN 752-1 : 1995 | DRAIN AND SEWER SYSTEMS OUTSIDE BUILDINGS - PART 1: GENERALITIES AND DEFINITIONS |
| BS 8005-4:1987 | Sewerage Guide to design and construction of outfalls |
| BS 8005-5:1990 | Sewerage Guide to rehabilitation of sewers |
| BS 8005-3:1989 | Sewerage Guide to planning and construction of sewers in tunnel |
| BS EN 752-1:1996 | Drain and sewer systems outside buildings Generalities and definitions |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.