BS EN ISO 10442:2002

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Basic design
  4.1 General
  4.2 Package
  4.3 Integrally geared compressor
  4.4 Driver
  4.5 Driver-to-compressor coupling and guard
  4.6 Intercoolers
5 Accessories
  5.1 Aftercooler
  5.2 Air intake filter-silencer
  5.3 Discharge blowoff silencer
6 Inspection, testing and preparation for shipment
  6.1 General
  6.2 Inspection
  6.3 Testing
  6.4 Preparation for ship
7 Vendor data
  7.1 Proposals
  7.2 Contract data
Annex A (informative) Data sheets
Annex B (informative) Material specifications for
        major component parts
Annex C (informative) Diagrams (see ISO 10439)
Annex D (normative) Forces and moments
Bibliography

Defines requirements and gives recommendations for the design, materials, fabrication, inspection, testing and preparation for shipment of constant-speed, packaged, integrally geared centrifugal air compressors, including their accessories, for use in the petroleum, chemical and gas service industries.

This International Standard specifies requirements and gives recommendations for the design, materials, fabrication, inspection, testing and preparation for shipment of constant-speed, packaged, integrally geared centrifugal air compressors, including their accessories, for use in the petroleum, chemical and gas service industries. It is also applicable to gas services other than air that are non-hazardous and non-toxic. It is not applicable to machines that develop a pressure rise of less than 35kPa above atmospheric pressure, which are classed as fans or blowers.

NOTE In this International Standard, where practical, US customary units have been included in brackets for information.