BS EN ISO 18563-2:2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing. Characterization and verification of ultrasonic phased array equipment Probes
Hardcopy , PDF
04-10-2024
English
21-09-2017
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 General compliance
6 Technical information for phased array probes
7 Test equipment
8 Performance tests for phased array probes
Bibliography
Defines the characterization tests performed at the end of the fabrication of a phased array probe. Also defines both methodology and acceptance criteria.
| Committee |
WEE/46
|
| DevelopmentNote |
Supersedes BS EN 16392-2. (10/2017)
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This document specifies the characterization tests performed at the end of the fabrication of a phased array probe. It defines both methodology and acceptance criteria. This document is applicable to the following phased array probes used for ultrasonic non-destructive testing in contact technique (with or without a wedge) or in immersion technique, with centre frequencies in the range 0,5MHz to 10MHz: non-matrix array probes: linear; encircling; partial annular sectorial (type \'daisy\'); 2D-matrix array probes. This document does not give methods and acceptance criteria to characterize the performance of an ultrasonic phased array instrument or the performance of a combined system. These are given in ISO18563‑1 and in ISO18563‑3 .
| Standards | Relationship |
| EN ISO 18563-2:2017 | Identical |
| ISO 18563-2:2017 | Identical |
| ISO 2400:2012 | Non-destructive testing — Ultrasonic testing — Specification for calibration block No. 1 |
| EN 16018:2011 | Non-destructive testing - Terminology - Terms used in ultrasonic testing with phased arrays |
| ISO 18563-3:2015 | Non-destructive testing — Characterization and verification of ultrasonic phased array equipment — Part 3: Combined systems |
| ISO 18563-1:2015 | Non-destructive testing — Characterization and verification of ultrasonic phased array equipment — Part 1: Instruments |
| ISO 5577:2017 | Non-destructive testing — Ultrasonic testing — Vocabulary |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.