BS EN ISO 28927-4:2010+A1:2018

This part of ISO28927 specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of straight grinders. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of a machine fitted with a specified test wheel and run under no-load conditions.This part of ISO28927 is applicable to hand-held machines (see Clause5), driven pneumatically or by other means, intended for grinding and surface finishing using straight grinding wheels type1, tapered wheels type4 and cylindrical plugs, e.g. of type16 (cylindrical plug, tapered cone), 18 (cylindrical plug, flat end), 18R (cylindrical plug, rounded end) and 19 (cylindrical plug, taper-roll shaped) and with wire brushes, for use on all kinds of materials. It is not applicable to die grinders where the inserted tool is mounted in a collet.NOTE1 Typical machines covered by this part of ISO28927 are illustrated in Figures1 to 3.It is intended that the results be used to compare different models of the same type of machine.NOTE2 To avoid confusion with the terms “power tool” and “inserted tool”, “machine” is used hereinafter for the former.