BS EN ISO 28927-6:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Basic standards and vibration test codes
5 Description of the family of machines
6 Characterization of vibration
7 Instrumentation requirements
8 Testing and operating conditions of the machinery
9 Measurement procedure and validity
10 Measurement report
Annex A (informative) - Model test report for vibration
        emission of rammers
Annex B (normative) - Determination of uncertainty
Annex C (normative) - Design of energy absorbers for rammers
Bibliography
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC, amended by Directive 98/79/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC

Describes a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held, power-driven rammers.

This part of ISO28927 specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held, power-driven rammers. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of a machine run under specified test conditions. It is intended that the results be used to compare different models of the same type of machine.

This part of ISO28927 is applicable to rammers, back-fill rammers, pawing rammers, sand rammers and stampers (see Clause5), driven pneumatically or by other means, intended for use in foundries, on building sites, etc., and with, for example, butts or peens made of cast iron or rubber, used for ramming of casting sand or in stamping work.

NOTE To avoid confusion with the terms “power tool” and “inserted tool”, machine is used for the former throughout this document.