BS EN ISO 377:2017

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Preparation of samples and selection
  of test pieces
6 Preparation of test pieces
Annex A (normative) - Location of samples
        and test pieces

Describes requirements for the identification, location and preparation of samples and test pieces intended for mechanical tests on steel sections, bars, rod, flat products and tubular products as defined in ISO 6929.

This document specifies requirements for the identification, location and preparation of samples and test pieces intended for mechanical tests on steel sections, bars, rod, flat products and tubular products as defined in ISO6929 . If agreed in the order, this document can also apply to other metallic products. These samples and test pieces are for use in tests that are carried out in conformity with the methods specified in the product or material standard or, in the absence of this, in the standard for the test method.

Where the requirements of the order or product standard differ from those given in this document, then the requirements of the order or product standard apply.