BS EN ISO 9445-1:2010

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery conditions
6 Tolerances on thickness for cold-rolled narrow strip
   and products obtained from cold-rolled narrow strip
7 Tolerances on width for cold-rolled narrow strip and
   products obtained from cold-rolled narrow strip
8 Preferred coil inner diameters for cold-rolled narrow
   strip
9 Tolerances on length for cut lengths obtained from
   cold-rolled narrow strip
10 Tolerances on edge camber for cold-rolled narrow strip
   and cut lengths obtained from cold-rolled narrow strip
11 Tolerances on squareness for cut lengths obtained from
   cold-rolled narrow strip
12 Tolerances on flatness for cut lengths obtained from
   cold-rolled narrow strip
13 Edge waviness tolerances for cold-rolled strip
14 Form of coils
15 Ordered format for cut lengths
16 Measurement of thickness for cold-rolled narrow strip
   and cut lengths obtained from cold-rolled narrow strip
17 Measurement of width
18 Measurement of length
19 Measurement of edge camber
20 Measurement of squareness
21 Measurement of flatness and waviness

Describes the tolerances on dimensions and form for continuously cold-rolled stainless steel narrow strip, in thicknesses of up to and including 3 mm and in rolling widths of less than 600 mm.

This part of ISO9445 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel narrow strip, in thicknesses of up to and including 3mm and in rolling widths of less than 600mm. It also applies to cut lengths taken from such strip.

Narrow strip and cut lengths with widths of less than 600mm, which are manufactured from wide strip by longitudinal slitting, are covered in ISO9445-2.