BS IEC 62153-4-15:2015

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Physical background
5 Principle of the test methods
6 Test procedures
7 Sample preparation
8 Transfer impedance (short - matched)
9 Screening attenuation
10 Coupling attenuation
11 Coupling transfer function
Annex A (informative) - Principle of the triaxial test
        procedure
Annex B (informative) - Triaxial cell
Annex C (informative) - Cut off frequencies, higher
        order modes
Annex D (informative) - Coupling transfer function
Annex E (informative) - Attenuation versus scattering
        parameter S[21]
Annex F (informative) - Application of a moveable
        shorting plane
Annex G (informative) - Correction in case the receiver
        input impedance R is higher than the characteristic
        impedance of the outer circuit Z[2]
Bibliography

Defines the procedures for measuring with triaxial cell the transfer impedance, screening attenuation or the coupling attenuation of connectors, cable assemblies and components, e.g. accessories for analogue and digital transmission systems and equipment for communication networks and cabling (in accordance with the scope of IEC technical committee 46).

This part of IEC 62153 specifies the procedures for measuring with triaxial cell the transfer impedance, screening attenuation or the coupling attenuation of connectors, cable assemblies and components, e.g. accessories for analogue and digital transmission systems and equipment for communication networks and cabling (in accordance with the scope of IEC technical committee 46).

Measurements can be achieved by applying the device under test direct to the triaxial cell or with the tube in tube method in accordance with IEC 62153-4-7.