BS ISO 10904:2011

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols, abbreviations and units
5 Product requirements
6 Evaluation of conformity
7 Test requirements
8 Marking
Annex A (normative) - Consignment and inspection sampling
Annex B (normative) - Dimensional and geometrical testing
        procedures
Annex C (normative) - Test method to determine the breaking
        load and the bending modulus of sheets
Annex D (normative) - Test method to determine the bending
        moment of a sheet
Annex E (normative) - Statistical method for determining the
        corresponding wet values or revised dry specifications
        for the breaking load and/or bending moment when
        carrying out the dry method of test or when testing
        prior to coating for quality control purposes
Annex F (normative) - Test method to determine
        the apparent density
Annex G (normative) - Test method to determine the water
        permeability of a sheet
Annex H (normative) - Test method to determine the
        freeze-thaw performance of sheets and fittings
Annex I (normative) - Test method to determine the
        heat-rain performance of sheets
Annex J (normative) - Test method to determine the
        warm water performance of long and short sheets
Annex K (normative) - Test method to determine the
        soak-dry performance of long and short sheets
Bibliography

Describes technical requirements and methods for the inspection and testing of straight short and long fibre-cement profiled sheets and their fibre-cement fittings designed to provide the weather-exposed surfaces on roofs and internal and external walls of buildings.

This International Standard specifies technical requirements and methods for the inspection and testing of straight short and long fibre-cement profiled sheets and their fibre-cement fittings designed to provide the weather-exposed surfaces on roofs and internal and external walls of buildings.

Products covered by this International Standard can be used for other purposes, provided they comply with the appropriate national or international application code or standard.

Some of the requirements of this International Standard can apply, after agreement between manufacturer and purchaser, to curved profiled sheets.

The type tests described in this International Standard are not intended to evaluate the performance of the coating in isolation (colour-fastness, adhesion, etc.). Specific performance requirements for coatings are referenced in other International Standards or national standards.

This International Standard does not apply to fibre-cement profiled sheets and fittings reinforced with asbestos fibres.