BS ISO 12219-5:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Instrument and reagent
6 Unit component sample preparation
7 Verification of test conditions
8 Standard test procedure
9 Calculation of unit component values
10 Test report
11 Quality assurance/quality control (QA/QC)
12 Safety measures
Annex A (informative) - General description of the
        static test chamber
Annex B (informative) - Example of airtightness test
        and temperature stability of entire phases
Annex C (informative) - Comparison of VOCs concentration
        between the buffer bag inside and the
        static chamber inside
Annex D (informative) - A dynamic mode operation
Annex E (informative) - Comparison of the static mode and
        the dynamic mode operation
Annex F (informative) - Correlation between the
        assembly-based method (ISO 12219-4)
        and the unit component-based method
        (ISO 12219-5)
Annex G (informative) - Correlation between the unit
        component-based method (ISO 12219-5)
        and the material-base method (ISO 12219-3)
Bibliography

Defines a chamber based, static headspace type method for measuring volatile organic compounds (VOCs), formaldehyde and other carbonyl compounds which may diffuse from vehicle interior unit components into the cabin air.

This part of ISO12219 specifies a chamber based, static headspace type method for measuring volatile organic compounds (VOCs), formaldehyde and other carbonyl compounds which may diffuse from vehicle interior unit components into the cabin air. The chamber emission test is intended to provide characteristic emission of unit component to car interior of assembly level emission. It also specifies the emission test chamber, preparation of the test specimen, connection of the vapour sampling devices and test conditions. This method is valid for new car interior unit components intended for vehicles, and can also be used for car interior unit components disassembled from assembly of car interior trim or used cars. A set of multi-unit components could be applicable according to the test purpose.

A dynamic mode operation of emission chamber could be applied if corroborative information of the unit component emission between this method and small chamber method (ISO12219-4:2013) is desired.

The specified analytical procedure for VOCs (ISO16000-6) is valid for the determination of VOCs ranging in concentration from sub-µg/m³ to several mg/m³. The method is applicable to the measurement of non-polar and slightly polar VOCs ranging in volatility from n-C₆ to n-C₁₆. Some very volatile compounds (VVOC) and semi-volatile organic compounds (SVOC) can also be analysed (see informative AnnexD of ISO16000-6:2011).

This part of ISO12219 is complementary to existing standards and provides third party test laboratories and manufacturing industry with an approach for:

• comparing emissions from various unit components (sub-assemblies) with VOC emissions from related complete assemblies measured in other tests,

• evaluating and categorising specific unit components by their VOC emission data,

• comparing and correlating emission from unit components with VOC emission data obtained in other tests for the various materials used to make the unit component,

• evaluating prototype, “low-emission?? unit components during development.

NOTE 1 All volatile carbonyls except formaldehyde can be analysed by ISO16000-6:2011 incorporating informative AnnexD.

NOTE 2 The dynamic mode operation is described in the informative AnnexD of this part of ISO12219.