BS ISO 1275:2006

Foreword
Introduction
1 Scope
2 Normative references
3 Transmission chains
  3.1 Assembly and component nomenclature
  3.2 Designation
  3.3 Dimensions
  3.4 Tensile testing
  3.5 Preloading
  3.6 Length validation
  3.7 Marking
4 Conveyor chains
  4.1 General
  4.2 Nomenclature
  4.3 Designation
  4.4 Dimensions
  4.5 Length validation
  4.6 Marking
  4.7 Attachments
5 Sprockets
  5.1 Nomenclature
  5.2 Diametral dimensions and tooth shape
  5.3 Radial run-out
  5.4 Axial run-out (wobble)
  5.5 Pitch accuracy of sprocket teeth
  5.6 Bore tolerance
  5.7 Marking
Annex A (normative) Pitch circle diameters

Describes requirements for double-pitch precision roller chains suitable for the mechanical transmission of power and for conveyors, together with those for their associated sprockets.

This International Standard specifies requirements for double-pitch precision roller chains suitable for the mechanical transmission of power and for conveyors, together with those for their associated sprockets. It covers dimensions, tolerances, length measurement, preloading and minimum tensile strengths.

These double-pitch chains have been derived from some of the short-pitch transmission precision roller chains covered by ISO606 having certain common dimensions but of double the pitch.

The chains are intended for use under less onerous conditions with respect to speed and power transmitted than are the base chains from which they are derived.

This International Standard primarily applies to sprockets with 5 to 75 teeth inclusive (with intermediate numbers of teeth 51/2 to 741/2 inclusive).

The preferred numbers of teeth are 7, 9, 10, 11, 13, 19, 27, 38 and 57.