BS ISO 13012:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Rolling bearings, linear motion, recirculating ball, sleeve type. Accessories
Hardcopy , PDF
31-08-2009
English
15-12-1999
Important note : Users cannot be edited or removed once added to your Multi user PDF.
National Foreword
Foreword
Introduction
1 Scope
2 Normative References
3 Symbols
4 Housings
5 Shaft Support Rails
6 Shaft Support Blocks
7 Shafts
Table 1 - Housings, Flangeless, Closed and Adjustable Types
of Series 1 Linear Motion Rolling Bearings
Table 2 - Housings, Flanged, Closed and Adjustable Types of
Series 3 Linear Motion Rolling Bearings
Table 3 - Housings, Flanged, Open Type for Series 3 Linear
Motion Rolling Bearings
Table 4 - Housings, Flangeless, Closed and Adjustable Types
for Series 3 Linear Motion Rolling Bearings
Table 5 - Housings, Flangeless, Open and Open Adjustable
Types for Series 3 Linear Motion Rolling Bearings
Table 6 - Shaft Support Rails for Linear Motion Rolling
Bearings
Table 7 - Shaft Support Rails, Low Height Type for Linear
Motion Rolling Bearings
Table 8 - Shaft Support Blocks, Flanged Type
Table 9 - Shaft Support Blocks, Flangeless Type
Table 10 - Shafts, Solid and Tubular for Linear Motion
Rolling Bearings
Table 11 - Shaft Length Tolerances
Specifies the boundary dimensions and other relevant dimensions of bearing housings, shafts, shaft support blocks and shaft support rails.
| Committee |
MCE/7
|
| DevelopmentNote |
Supersedes 95/717011 DC. (08/2004)
|
| DocumentType |
Standard
|
| Pages |
24
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| BS 7637:1993 | Specification for linear motion, recirculating ball, sleeve type rolling bearings (metric series) |
| ISO 468:1982 | Surface roughness — Parameters, their values and general rules for specifying requirements |
| ISO 286-2:2010 | Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |
| ISO 3754:1976 | Steel — Determination of effective depth of hardening after flame or induction hardening |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.