BS ISO 13041-5:2015

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Preliminary remarks
5 Tests described in Annexes A to C
Annex A (normative) - Kinematic tests for machines
        with a horizontal workholding spindle
Annex B (normative) - Kinematic tests for machines
        with a vertical workholding spindle
Annex C (normative) - Kinematic tests for machines
        with inverted vertical workholding spindles
Annex D (informative) - Precautions for test setup
        for AK6, BK6, and CK6
Bibliography

Defines, with references to ISO 230-1 and ISO 230-4, certain kinematic tests for numerically controlled (NC) turning machines and turning centres, concerning the spindle speeds, the feed speeds of the individual NC linear axes, and the accuracy of the paths described by the simultaneous movement of two or more NC linear and/or rotary axes.

This part of ISO13041 specifies, with references to ISO230-1 and ISO230-4, certain kinematic tests for numerically controlled (NC) turning machines and turning centres, concerning the spindle speeds, the feed speeds of the individual NC linear axes, and the accuracy of the paths described by the simultaneous movement of two or more NC linear and/or rotary axes.

NOTE This part of ISO13041 applies to numerically-controlled turning machines and turning centres with horizontal, vertical, and inverted vertical type workholding spindle(s).