Skip to content
Please enter a keyword to search

  • BS ISO 15118-3 : 2015

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    ROAD VEHICLES - VEHICLE TO GRID COMMUNICATION INTERFACE - PART 3: PHYSICAL AND DATA LINK LAYER REQUIREMENTS

    Available format(s):  Hardcopy, PDF

    Superseded date:  31-05-2016

    Language(s):  English

    Published date:  01-01-2015

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Symbols and abbreviated terms
    5 Conventions
    6 System architecture
    7 Connection coordination
    8 Timings and constants
    9 Matching EV - EVSE process
    10 EMC requirements
    11 Signal coupling
    12 Layer 2 interfaces
    Annex A (normative) - HomePlug Green PHY on control
            pilot line
    Annex B (informative) - IEEE 1901.2 G3-PLC profile on
            control pilot line
    Bibliography

    Abstract - (Show below) - (Hide below)

    Describes the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1].

    General Product Information - (Show below) - (Hide below)

    Committee AUE/16
    Development Note Supersedes 12/30246906 DC. (06/2015) Renumbered and superseded by BS EN ISO 15118-3. (05/2016)
    Document Type Standard
    Publisher British Standards Institution
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 62196-2:2016 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
    IEC TS 62763:2013 Pilot function through a control pilot circuit using PWM (pulse width modulation) and a control pilot wire
    IEC 62196-3:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers
    ISO 15118-1:2013 Road vehicles Vehicle to grid communication interface Part 1: General information and use-case definition
    ISO 15118-2:2014 Road vehicles Vehicle-to-Grid Communication Interface Part 2: Network and application protocol requirements
    IEC 61851-1:2017 Electric vehicle conductive charging system - Part 1: General requirements
    IEC 62196-1:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective