BS ISO 17165-1:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
5 Hose types, nominal inside diameters and maximum
   working pressures, and correspondence of hose
   sizes to tube sizes
6 Dimensions of hose and hose fittings
7 Overview of hose type, type of hydraulic fluid and
   temperature range
8 Summary of hose fitting end forms and key dimensions
9 Requirements for manufacturing instructions for hose
   assemblies
10 Tolerances on hose assembly length and rotational angle
11 Pressure drop of hose assemblies
12 Requirements and tests
13 Marking
14 Identification statement (reference to this part of
   ISO 17165)
Annex A (informative) - Maximum working pressures of hoses
Annex B (informative) - Dimensions of steel tubes to be used in
        combination with hose types listed in Table A.1
Annex C (informative) - Key dimensions of the hose types covered
        in ISO 17165-1
Bibliography

Describes requirements for hose assemblies that are manufactured from hoses that conform to ISO 3949 and to all parts of ISO 1436, ISO 3862, ISO 4079 and ISO 11237 and hose fittings with elastomeric seals that conform to ISO 12151-1, ISO 12151-2, ISO 12151-3 and ISO 12151-6.

This part of ISO17165 specifies requirements for hose assemblies that are manufactured from hoses that conform to ISO3949 and to all parts of ISO1436, ISO3862, ISO4079 and ISO11237 and hose fittings with elastomeric seals that conform to ISO12151-1, ISO12151-2, ISO12151-3 and ISO12151-6.

This part of ISO17165 contains information of the most important criteria for the selection of preferred types of hoses and hose fittings with elastomeric sealing for use in hydraulic fluid power applications.

Recommendations for installation, storage, life cycle and the necessary inspections to ensure the full functionality of hose assemblies are given in ISO/TR17165-2.