BS ISO 17245:2015

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test method
5 Examination of surface and microstructure
  of corroded test pieces
6 Report
Annex A (informative) - Chemical and electrolytic procedures
        for removal of corrosion products
Bibliography

Describes the method for high temperature corrosion testing of metallic materials by immersing in molten salt or other liquids which are under static conditions and exposing them to high temperature in a controlled gas environment to evaluate their corrosion resistance.

This International Standard specifies the method for high temperature corrosion testing of metallic materials by immersing in molten salt or other liquids which are under static conditions and exposing them to high temperature in a controlled gas environment to evaluate their corrosion resistance. Two options are considered using a stagnant inert gas environment, and using a flowing reactive gas environment. This International Standard does not cover methods where test pieces are fully or partially embedded in a corrosive powder made up of salt, ash, and/or other solids, or cases in which a surface deposit is applied to the specimens. These methods are covered in ISO17248 and ISO17224, respectively. This International Standard is not applicable to the situation of test pieces in relative movement to their surrounding corrosive liquid. NOTE This situation is intended to be dealt with in a future International Standard.