BS ISO 18672-1:2009
Current
The latest, up-to-date edition.
Plastics piping systems for non-pressure drainage and sewerage. Polyester resin concrete (PRC) Pipes and fittings with flexible joints
Hardcopy , PDF
English
30-06-2009
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
PRI/88
|
| DevelopmentNote |
Supersedes 05/30137614 DC. (07/2009) Reviewed and confirmed by BSI, November 2014. (10/2014)
|
| DocumentType |
Standard
|
| Pages |
78
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This part of ISO18672 specifies definitions, requirements and characteristics of pipes, fittings, joints, materials, test methods and marking for pipes and fittings made from polyester resin concrete (PRC), intended to be used within a drain or sewer system operating without pressure. It applies to products for use in buried installations to be installed by open-trench techniques or pipe jacking.
It applies to pipes, fittings and their joints of nominal sizes from DN 150 to DN 3000 for circular cross-sections, from WN/HN 300/450 to WN/HN 1400/2100 for egg-shaped cross-sections and from DN 800 to DN 1800 for kite-shaped cross-sections.
The intended use of these products is for the conveyance of sewage, rainwater and surface water at temperatures up to 50°C, without pressure or occasionally at a head of pressure up to 0,5 bar1), and installed in areas subjected to vehicle and/or pedestrian traffic.
The pipes are classified on the basis of the intended method of installation and cross-sectional shape.
NOTE It is the responsibility of the purchaser or specifier to make the appropriate selections, taking into account the particular requirements and any relevant national regulations and installation practices or codes.
| Standards | Relationship |
| ISO 18672-1:2009 | Identical |
| EN 13121-1:2003 | GRP tanks and vessels for use above ground - Part 1: Raw materials - Specification conditions and acceptance conditions |
| ISO 7510:2017 | Plastics piping systems — Glass-reinforced plastics (GRP) components — Determination of the amounts of constituents |
| ISO 10928:2016 | Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use |
| ISO 8639:2016 | Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods for leaktightness and proof of structural design of flexible joints |
| ISO 75-2:2013 | Plastics — Determination of temperature of deflection under load — Part 2: Plastics and ebonite |
| ISO 3126:2005 | Plastics piping systems Plastics components Determination of dimensions |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.