BS ISO 19899:2010
Current
The latest, up-to-date edition.
Plastics piping systems. Polyolefin pipes and mechanical fitting assemblies. Test method for the resistance to end load (AREL test)
Hardcopy , PDF
English
30-11-2010
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Test piece
7 Procedure
8 Test report
Annex A (normative) - End load forces for PE 80 pipes
and PE 100 pipes
Bibliography
Describes a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of d[n] less than or equal 63 mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long-term application of a constant and longitudinally applied force.
| Committee |
PRI/88
|
| DevelopmentNote |
Supersedes 05/30127475 DC. (11/2010) Reviewed and confirmed by BSI, February 2016. (02/2016)
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This International Standard specifies a method to determine, for mechanically jointed polyolefin pipe and fitting assemblies in sizes of dn≤63mm, the effect of component relaxation and creep on the resistance of the assembly to pipe pull out under the long-term application of a constant and longitudinally applied force.
The susceptibility of the polyolefin pipe to stress crack failure initiated by the joint assembly is also examined.
NOTE For sizes dn>63mm, the method is under development.
| Standards | Relationship |
| ISO 19899:2010 | Identical |
| ISO 1167-4:2007 | Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 4: Preparation of assemblies |
| ISO 3:1973 | Preferred numbers Series of preferred numbers |
| ISO 497:1973 | Guide to the choice of series of preferred numbers and of series containing more rounded values of preferred numbers |
| ISO 3458:2015 | Plastics piping systems Mechanical joints between fittings and pressure pipes Test method for leaktightness under internal pressure |
| ISO 1167-1:2006 | Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 1: General method |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.