BS ISO 20808:2016

Current

Current The latest, up-to-date edition.

Fine ceramics (advanced ceramics, advanced technical ceramics). Determination of friction and wear characteristics of monolithic ceramics by ball-on-disc method

Available format(s):

Language(s):

Published date: 31-07-2016

Publisher: British Standards Institution

Table of Contents - (Show below) - (Hide below)

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Test materials and specimen preparation
6 Apparatus
7 Testing procedure
8 Calculation of test results
9 Test report
Bibliography

Abstract - (Show below) - (Hide below)

Gives a procedure for and provides guidance on the determination of the coefficient of friction and the specific wear rate for monolithic ceramics.

General Product Information - (Show below) - (Hide below)

Committee	RPI/13
Development Note	Supersedes 15/30324532 DC. (08/2016)
Document Type	Standard
ISBN
Pages
Published
Publisher	British Standards Institution
Status	Current
Supersedes	15/30324532 DC : 0

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 20808:2016	Identical

Standards Referencing This Book - (Show below) - (Hide below)

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
ISO 4287:1997	Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters
ISO 18754:2013	Fine ceramics (advanced ceramics, advanced technical ceramics) Determination of density and apparent porosity
ISO 1101:2017	Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
ISO 3274:1996	Geometrical Product Specifications (GPS) — Surface texture: Profile method — Nominal characteristics of contact (stylus) instruments
ASTM G 99 : 2017 : REDLINE	Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
ISO 80000-1:2009	Quantities and units — Part 1: General
ISO 3611:2010	Geometrical product specifications (GPS) — Dimensional measuring equipment: Micrometers for external measurements — Design and metrological characteristics
DIN 50324:1992-07	TRIBOLOGY; TESTING OF FRICTION AND WEAR MODEL TEST FOR SLIDING FRICTION OF SOLIDS (BALL ON DISC SYSTEM)

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart