BS ISO 3547-5:2007

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

Plain bearings. Wrapped bushes Checking the outside diameter

Available format(s):

Superseded date: 13-05-2020

Language(s):

Published date: 30-11-2007

Publisher: British Standards Institution

Table of Contents - (Show below) - (Hide below)

Foreword
1 Scope
2 Normative references
3 Symbols and units
4 Outside diameter, D[o]
5 Purpose of checking
6 Methods of checking
7 Selection of checking method for outside diameter
8 ISO 3547-2, test A - Outside diameter, D[o]
9 ISO 3547-2:2006, test B - Outside diameter, D[o]
10 ISO 3547-2:2006, test D - Outside diameter,
D[o] > 120 mm
11 Specifications on drawings of bushes
12 Specifications for control of the checking equipment
Bibliography

Abstract - (Show below) - (Hide below)

Describes the following ISO 12301, the checking of the outside diameter of wrapped bushes (ISO 3547-2:2006, methods A, B and D) and describes the necessary checking methods and measuring equipment.

General Product Information - (Show below) - (Hide below)

Committee	MCE/12
Development Note	Supersedes BS 4480-9(1995). (11/2007) Supersedes 06/30145636 DC. (12/2007)
Document Type	Standard
ISBN
Pages
Published
Publisher	British Standards Institution
Status	Superseded
Superseded By	BS ISO 3547-5:2020
Supersedes	06/30145636 DC : DRAFT JULY 2006 BS 4480-9:1995

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 3547-5:2007	Identical

Standards Referencing This Book - (Show below) - (Hide below)

ISO 12301:2007	Plain bearings — Quality control techniques and inspection of geometrical and material quality characteristics
ISO 3547-1:2006	Plain bearings Wrapped bushes Part 1: Dimensions
ISO 3547-6:2007	Plain bearings Wrapped bushes Part 6: Checking the inside diameter
ISO 3547-7:2007	Plain bearings Wrapped bushes Part 7: Measurement of wall thickness of thin-walled bushes
ISO 3547-2:2017	Plain bearings — Wrapped bushes — Part 2: Test data for outside and inside diameters
ISO 286-1:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits
ISO 286-2:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO/R 1938:1971	ISO system of limits and fits Part II : Inspection of plain workpieces

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart