BS ISO 3739-3:2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Industrial tyres and rims Rims
24-11-2021
29-02-2008
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designation and marking
5 Rim profiles
Annex A (normative) Size range of existing rims
Bibliography
Describes the main requirements, including size designation and marking, of 5 degree tapered and flat base rims, with diameters not exceeding rim diameter code 15 for pneumatic tyres and for solid tyres for pneumatic tyre rims, primarily intended for industrial vehicles for use on prepared surfaces.
Committee |
AUE/4
|
DevelopmentNote |
Supersedes BS AU50-4.5.2(1996). (02/2008) Supersedes 04/30117550 DC. (03/2008)
|
DocumentType |
Standard
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
This part of ISO3739 specifies the main requirements, including size designation and marking, of 5° tapered and flat base rims, with diameters not exceeding rim diameter code 15 for pneumatic tyres and for solid tyres for pneumatic tyre rims, primarily intended for industrial vehicles for use on prepared surfaces.
ISO3739-1 gives the designation, dimensions and marking, and ISO3739-2 gives the load ratings, of pneumatic tyres (metric series). ISO10499-1 covers the designation, dimensions and marking of rubber solid tyres (metric series) for pneumatic tyre rims.
Rim dimensions are specified for size and contour only. The tyre and wheel/rim manufacturers are consulted for confirmation of the suitability of the tyre/rim combinations, particularly with regard to rim profile and wheel strength.
Standards | Relationship |
ISO 3739-3:2008 | Identical |
ISO 3739-1:2007 | Industrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and marking |
ISO 3911:2004 | Wheels and rims for pneumatic tyres Vocabulary, designation and marking |
ISO 10499-1:1991 | Industrial tyres and rims Rubber solid tyres (metric series) for pneumatic tyre rims Part 1: Designation, dimensions and marking |
ISO 4251-3:2006 | Tyres (ply rating marked series) and rims for agricultural tractors and machines Part 3: Rims |
ISO 3739-2:1992 | Industrial tyres and rims — Part 2: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Load ratings |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.