BS ISO 6356:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Sampling and selection of specimens
7 Preconditioning of specimens, PE-foam,
   PE-foil and rubber mats
8 Atmosphere for conditioning and testing
9 Test procedures
10 Calculation and expression of results
11 Test report
Annex A (normative) - Specification of the sandals
Annex B (normative) - Standard sole material - Neolite
        (standard XS-664P)
Annex C (normative) - Standard sole material - BAM-rubber
Annex D (normative) - Method for measuring the electrical
        resistance of the footwear
Annex E (normative) - Example of a hand-held electrode
        and its use
Annex F (informative) - Method of checking calibration of
        the measuring system
Bibliography

Describes a method of evaluating the electrostatic propensity of textile and laminate floor coverings under controlled conditions.

This International Standard specifies a method of evaluating the electrostatic propensity of textile and laminate floor coverings under controlled conditions. Since the potential generated varies with humidity, shoe materials, walk surface and individuals\' mannerisms, the values generated by this test will not necessarily reflect actual field experience, but will provide a relative comparison of the performance of different surfaces.

For classification purposes and in cases of dispute, the measurement procedure specified in this International Standard can be used under controlled conditions specified in the relevant classification standard or agreed between disputing parties. There may be occasions where measurements are required under non-controlled conditions, e.g. in situ measurements on installed floor coverings. The principle of measurement using the equipment specified in this International Standard can be used to make measurements, either with the standard footwear specified or with specific footwear relevant to the end use.