BS ISO 8434-6:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Materials
5 Pressure/temperature requirements
6 Designation of connectors
7 Requirements for tubes
8 Across-flats dimensions and tolerances
9 Design
10 Screw threads
11 Manufacture
12 Assembly instructions
13 Procurement information
14 Marking of components
15 Performance and qualification test
16 Identification statement (reference to this
   part of ISO 8434)
Annex A (informative) - Preferred thread undercut details
        when bonded washer type seal is used
Bibliography

Describes general and dimensional requirements for the design and performance of 60 degree cone connectors and braze-on nipples with or without O-ring sealing, made of steel for tube outside diameters of 6 mm through 50 mm, inclusive, or hose sizes 5 through 51, inclusive.

This part of ISO 8434 specifies general and dimensional requirements for the design and performance of 60° cone connectors and braze-on nipples with or without O-ring sealing, made of steel for tube outside diameters of 6 mm through 50 mm, inclusive, or hose sizes 5 through 51, inclusive. These connectors are for use in fluid power and general applications within the limits of pressure and temperature specified in this part of ISO 8434.

They are intended for the connection of tubes and hose fittings to ports in accordance with ISO 6149-1 and ISO 1179-1. See ISO 12151-6 for related hose fitting specification.

These connectors provide full-flow connections in hydraulic systems operating to the working pressures shown in Table 1.

NOTE 1 For new designs in hydraulic fluid power applications, see the requirements given in 9.6. Where the requirements of the application allow for the use of elastomeric seals, connector designs that conform to International Standards and incorporate elastomeric sealing are preferred.

NOTE 2 For use under conditions outside the pressure and/or temperature limits specified, see 5.3.