BS ISO/IEC 18000-3:2010

Foreword
Introduction
1 Scope
2 Conformance
3 Normative references
4 Terms and definitions
5 Symbols and abbreviated terms
6 Requirements: Physical layer, collision management
  system and protocol values for 13,56 MHz systems
7 Marking of equipment
Annex A (informative) - MODE 1: mandatory and optional
        commands required to support the ISO/IEC 15962
        data protocol
Annex B (informative) - MODE 2 and MODE 3: Phase Jitter
        Modulation
Annex C (normative) - MODE3: State transition tables
Annex D (normative) - MODE 3: Command Response Tables
Annex E (normative) - MODE 3: Error codes
Annex F (normative) - MODE 3: Slot counter
Annex G (informative) - MODE 3: Example slot-count (Q)
        selection algorithm
Annex H (informative) - MODE 3: Example of tag inventory
        and access
Annex I (informative) - MODE 3: Calculation of 5-bit and
        16-bit cyclic redundancy checks
Annex J (informative) - MODE 3: ASK Method:
        Interrogator-to-tag link modulation
Annex K (informative) - MODE 3: Example data flow exchange
Annex L (informative) - MODE 3: Tag Features
Annex M (informative) - Cyclic Redundancy Check (CRC) (16 bit)
Annex N (informative) - Cyclic redundancy check (CRC) mode 2
        (32 bit)
Annex O (informative) - Known possible interferences between
        the MODES determined in this part of ISO/IEC 18000
Bibliography

Specifies physical layer, collision management system and protocol values for RFID systems for item identification operating at 13,56 MHz in accordance with the requirements of ISO/IEC 18000-1.

This part of ISO/IEC18000 provides physical layer, collision management system and protocol values for RFID systems for item identification operating at 13,56MHz in accordance with the requirements of ISO/IEC18000-1.

This part of ISO/IEC18000 provides definitions for systems for each MODE determined in Clause6 below.

This part of ISO/IEC18000 defines three non-interfering MODES.

• The MODES are not interoperable.

• The MODES, whilst not interoperable, are non-interfering.