CAN/CSA-ISO/IEC TR 18047-3:13 (R2017)

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conformance tests for ISO/IEC 18000-3 - 13,56 MHz
Annex A (normative) - Test setup parameters and dimensions
        for tags smaller than or equal to an ISO/IEC 7810 ID-1
        outline
Annex B (normative) - Guideline for RFID tags larger than
        ISO/IEC 7810 ID-1 size
Annex C (normative) - Test interrogator antenna
Annex D (informative) - Test interrogator antenna tuning
Annex E (normative) - Sense coil
Annex F (normative) - Reference tag for interrogator power test
Annex G (informative) - Reference tag for load modulation test
Annex H (informative) - Program for evaluation of the spectrum
Bibliography

Specifies test methods for determining the conformance of radio frequency identification devices (tags and interrogators) for item management with the specifications given in ISO/IEC 18000-3, but does not apply to the testing of conformity with regulatory or similar requirements.

Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the Canadian Advisory Committee (CAC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T). This Standard supersedes CAN/CSA-ISO/IEC TR 18047-3-05 (adoption of ISO/IEC TR 18047-3:2004). At the time of publication, ISO/IEC TR 18047-3:2011 is available from ISO and IEC in English only. Scope This part of ISO/IEC TR 18047 defines test methods for determining the conformance of radio frequency identification devices (tags and interrogators) for item management with the specifications given in ISO/IEC 18000-3, but does not apply to the testing of conformity with regulatory or similar requirements. The test methods require only that the mandatory functions, and any optional functions which are implemented, be verified. This can, in appropriate circumstances, be supplemented by further, application specific functionality criteria that are not available in the general case. This part of ISO/IEC TR 18047 includes the following interrogator and tag conformance parameters: mode-specific conformance parameters including nominal values and tolerances; parameters that apply directly affecting system functionality and inter-operability. This part of ISO/IEC TR 18047 does not include the following: parameters that are already included in regulatory test requirements; high-level data encoding conformance test parameters (these are specified in ISO/IEC 15962). Clause 5 describes all necessary conformance tests, while 5.3 applies to Mode 1 products only, 5.4 applies to Mode 2 products only and 5.5 applies to Mode 3 (mandatory ASK part) only.