CEI EN 60662 : 2013

FOREWORD
INTRODUCTION
1. Scope
2. Normative references
3. Terms and definitions
4. General lamp requirements
5. Marking
6. Dimensions
7. Caps
8. Test requirements for lamp starting, warm-up,
    electrical and photometric characteristics
9. Information for ballast and ignitor design
10. Information for luminaire design
11. Maximum lamp outlines
12. Numbering system for lamp data sheets
Annex A (normative) - Waveshape of voltage pulses
                      for lamp starting test
                      (schematic drawings)
Annex B (informative) - Diagrammatic data sheets for
                        location of lamp dimensions
Annex C (normative) - Guidance for determining
                      quadrilateral diagrams
Annex D (normative) - Measurement of voltage increase at
                      lamp terminals for luminaire Design
Annex E (informative) - HPS lamp drop-out voltage
                        measurement procedure
Annex F (normative) - Fixed settings of the ignition
                      device and requirements for ignition
Annex G (normative) - Method of measuring electrical and
                      photometrical characteristics
Annex H (normative) - Method of test for lumen
                      maintenance and life
Annex I (informative) - Maximum lamp outlines
Annex J (normative) - Lamp data sheets
Bibliography
ANNEX ZA (Normative) - normative references
                       to international publications
                       with their corresponding
                       european publications

Describes the performance requirements for high-pressure sodium vapour lamps for general lighting purposes which comply with the safety requirements of IEC 62035.