CEN/TS 16677:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Sampling and preparation of test samples
6 Simulation of wear and corrosion
7 Coating test
8 Release of nickel and its quantitative analytical
  detection (migration test)
Annex A (informative) - Cutting and masking of
        test samples (Coating test)
Annex B (normative) - Selection of test areas and
        wrapping (Migration test)
Bibliography

This document specifies the reference method for the testing of spectacle frames and sunglasses for nickel release. The reference method supports the demonstration of conformity with the limit value for nickel release of 0,5 µg/cm2/week set forth by European Regulation and makes provision for a uniform application and control of the European legislation in all member states.The reference method involves the following procedural steps (see also Clause 4):-Simulation of wear and corrosion;-EIS coating test (optional);-Laboratory test: Release of nickel and its quantitative analytical detection.This document applies to those parts of metal spectacle frames and those metal parts of combination spectacle frames that come into direct and prolonged contact with the skin of the wearer. This document also applies to those relevant metal parts of articles for eye and face protection, including sunglasses.The EIS coating test method can be applied only to metal parts which have been coated with an organic, electrically insulating, layer.This document does not apply to products other than spectacle frames and articles for eye and face protection, which includes sunglasses. NOTEThe reference method for products other than spectacle frames and of articles for eye and face protection, including sunglasses is specified in EN 1811:2011.