CGA C 23 : 2018
Current
The latest, up-to-date edition.
STANDARD FOR INSPECTION OF DOT/TC 3 SERIES AND ISO 11120 TUBE NECK MOUNTING SURFACES
Hardcopy
English
01-01-2018
Important note : Users cannot be edited or removed once added to your Multi user PDF.
1 Introduction
2 Scope
3 Definitions
4 Discussion about thread wear and local thin areas
5 Inspection and acceptance criteria for local thin areas
6 Inspection and acceptance criteria for thread wear
7 Disposition
8 Marking
9 References
Appendices
Appendix A - Thread dimensions (Informative)
Appendix B - Mounting thread inspection table-using
six inspection locations (Normative)
This publication applies to the inspection and evaluation of DOT/TC 3-Series and ISO 11120 tubes 12 ft (3.7 m) or longer with an outside diameter greater than or equal to 18 in (457 mm) that are supported by the neck mounting surface.
| DocumentType |
Standard
|
| Pages |
16
|
| PublisherName |
Compressed Gas Association
|
| Status |
Current
|
| CGA TB 25 : 2013 | DESIGN CONSIDERATIONS FOR TUBE TRAILERS |
| CGA C 20 : 2014 | REQUALIFICATION STANDARD FOR METALLIC, DOT AND TC 3-SERIES GAS CYLINDERS AND TUBES USING ULTRASONIC EXAMINATION |
| CGA C 6 : 2013 | STANDARD FOR VISUAL INSPECTION OF STEEL COMPRESSED GAS CYLINDERS |
| CGA C 18 : 2005(R2012) | METHODS FOR ACOUSTIC EMISSION REQUALIFICATION OF SEAMLESS STEEL COMPRESSED GAS TUBES |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.