CLC/TS 50625-3-3:2017

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 De-pollution monitoring
5 Overview of the applicable methodologies - Applicable
   methodologies
6 Large appliances
7 Cooling and freezing appliances
8 CRT Display/FPD appliances
9 Lamps - introduction and analysis methodology
10 Small appliances
11 Protocol for components removed during a batch process
Annex A (normative) - Sampling protocol for the physically
        smallest non-metallic mechanical treatment fraction
Annex B (normative) - Sampling protocol for plastics
Annex C (normative) - Targets
Annex D (informative) - Target calculation
        example - Calculation example for large
        appliance
Annex AA (normative) - CRT and FPD: Sampling protocol
Annex BB (normative) - CRT: Analysis protocol for residual
         CRT glass in CRT fractions
Annex CC (normative) - CRT: Analysis protocol for fluorescent
         coating remaining on cleaned CRT glass
Annex DD (normative) - CRT: Analysis protocol for the
         lead oxide in separated panel glass
Annex EE (normative) - FPD: Main steps for Mass Balance
Annex FF (normative) - FPD: Analysis of the de-polluted
         physically smallest shredded mix fraction of flat
         panel displays
Annex GG (informative) - CRT: Background on analysis
         protocol for fluorescent coating remaining on
         cleaned CRT glass
Bibliography

Clause 1 of CLC/TS 50625-3-1:2015 is replaced with the following:This European Technical Specification is intended to be used in conjunction with CLC/TS 50625-3-1 Collection, logistics and treatment requirements for WEEE - Part 1: General treatment requirements, EN 50625 1, Collection, logistics and Treatment requirements for WEEE - Part 2-2: Treatment requirements for WEEE containing CRTs and flat panel displays, EN 50625-2-2 and Collection, logistics and treatment requirements for WEEE - Part 3-1: Specification for de-pollution - General, CLC/TS 50625-3-1.