CSA C108.6 : 0

Technical Committee on Electromagnetic Compatibility of
Radio Frequency Generators, Industrial, Scientific and
Medical
CSA Preface
Foreword
CISPR Preface
1 Scope and Object
2 Definitions
3 Frequencies Designated for ISM Use
4 Classification of ISM Equipment
   4.1 Separation Into Groups
   4.2 Division Into Classes
5 Limits of Electromagnetic Disturbances
   5.1 Limits of Terminal Disturbance Voltage
   5.2 Limits of Electromagnetic Radiation Disturbance
   5.3 Provisions for Protection of Specific Safety
        Services
6 Assessment of Conformity of Equipment
   6.1 Equipment in Series Production
   6.2 Equipment Produced on an Individual Basis
   6.3 Statistical Assessment of Compliance of Series
        Produced Equipment
7 General Measurement Requirements
   7.1 Ambient Noise
   7.2 Measuring Equipment
   7.3 Frequency Measurement
   7.4 Configuration of Equipment Under Test
   7.5 Load Conditions of Equipment Under Test
8 Special Provisions for Test Site Measurements
   (9 kHz to 1 GHz)
   8.1 Radiation Test Site for 9 kHz to 1 GHz
   8.2 Measurement of Mains Terminal Disturbance Voltage
9 Radiation Measurements: 1 GHz to 18 GHz
   9.1 Test Arrangement
   9.2 Receiving Antenna
   9.3 Validation and Calibration of Test Site
   9.4 Measuring Procedure
10 Measurement "In situ"
11 Safety Precautions
Figures
Annexes
A - Examples of Equipment Classification
B - Precautions to be Taken in the Use of a Spectrum
    Analyser
C - Measurement of Electromagnetic Radiation Disturbance
    in the Presence of Signals from Radio Transmitters
D - Propagation of Interference from Industrial RF
    Equipment at Frequencies Between 30 MHz and 300 MHz

Specifies the limits and procedures of measurement applicable to industrial, scientific and medical (ISM) equipment and to spark erosion equipment.