CSA ISO/IEC 19823-10:20

CSA Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the SCC Mirror Committee (SMC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T). At the time of publication, ISO/IEC 19823-10:2020 is available from ISO and IEC in English only. CSA Group will publish the French version when it becomes available from ISO and IEC. The International Standard was reviewed by the CSA TCIT under the jurisdiction of the CSA Strategic Steering Committee on Information and Communications Technology and deemed acceptable for use in Canada. From time to time, ISO/IEC may publish addenda, corrigenda, etc. The TCIT will review these documents for approval and publication. For a listing, refer to the Current Standards Activities page at standardsactivities.csa.ca. This Standard has been formally approved, without modification, by the Technical Committee and has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope This document describes test methods for determining the conformance of security crypto suites defined in ISO/IEC 29167-10. This document contains conformance tests for all mandatory and applicable optional functions. The conformance parameters are the following: — parameters that apply directly affecting system functionality and inter-operability; — protocol including commands and replies; — nominal values and tolerances. Unless otherwise specified, the tests in this document are intended to be applied exclusively to RFID Tags and Interrogators defined in the ISO/IEC 15693 series and in the ISO/IEC 18000 series using ISO/IEC 29167-10.