DD CEN/TS 15844-2:2010

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Usage limitations - Requirement for a special issuer
   code
6 Value range limitations
7 Encoding specification
8 Printing of the bar code
9 Reading and interpretation of BNB-78 bar codes
10 Conversion to the message and binary representations
Annex A (informative) - Error detection and correction
        algorithms
Annex B (informative) - S18 ID-tag 78-position BNB bar
        code template
Bibliography

Gives the representation of ID-tags as a 78-position bar-no-bar code (BNB-78) printed in fluorescent ink in area R1 on the reverse side of items.

This part of the Technical Specification defines the representation of ID-tags as a 78-position bar-no-bar code (BNB-78) printed in fluorescent ink in area R1 on the reverse side of items. BNB-78 encoding is one of two encoding specifications supported by this Technical Specification ) for the printing of ID-tags in area R1, the other being BNB-62, which is specified in CEN/TS 15844-3. NOTE 1 Representation in the form of a 4-state code printed on the front of the item is covered in CEN/TS 15844-4 for flats and CEN/TS 15844-5 for small letters. BNB-78 encoding supersedes the earlier specified BNB-62 encoding and shall be applied in all cases in which ID-tags are placed in area R1 on the reverse side of letter mail items of size up to and including C5, by issuers other than those explicitly authorised to continue use of BNB-62 encoding, namely An Post (Ireland), Canada Post and United States Postal Service. NOTE 2 ID-tags encoded in area R1 are required by article RL 123 of the UPU Letter Post Regulations [1] to be compliant with UPU standard S18 – and by this with the related CEN/TS 15844. This supports only two encodings in area R1, namely BNB-78 as defined herein and BNB-62 as defined in CEN/TS 15844-3. The latter is authorised for continued use only by the three issuers mentioned above. Where ID-tags are used, and are applied in area R1 on the reverse side of letter mail items of size up to and including C5, the use of BNB-78 encoding is mandatory for all other issuers. NOTE 3 BNB-78 encoding is not considered suitable for use on flats. CEN/TS 15844-4 defines a 4-state encoding which may be used for this purpose.