DD IEC/PAS 61169-41:2009

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Mating face and gauge information
  3.1 Dimensions-general connectors - Grade 2
      3.1.1 Connector with pin-centre contact
      3.1.2 Connector with socket-centre contact
  3.2 Gauges
      3.2.1 Gauge pins for socket-centre contact
      3.2.2 Test procedure
      3.2.3 Gauge pins for outer contact of connector with
            pin-centre
      3.2.4 Test procedure
  3.3 Dimensions-standard test connectors - Grade 0
      3.3.1 Connector with pin-centre contact
      3.3.2 Connector with socket-centre contact
4 Quality assessment procedure
  4.1 General
  4.2 Rating and characteristics
  4.3 Test schedule and inspection requirements - Acceptance
      tests
      4.3.1 Acceptance tests
      4.3.2 Periodic tests
  4.4 Procedures
      4.4.1 Quality conformance inspection
      4.4.2 Qualification approval and its maintenance
5 Instructions for preparation of detail specifications
  5.1 General
  5.2 Identification of the component
  5.3 Performance
  5.4 Marking, ordering information and related matters
  5.5 Selection of tests, test conditions and severities
  5.6 Blank detail specification pro-forma for type CQA
      connector
Annex A (normative) - Adjunct for SMA intermateability

Offers information and rules for preparation of detail specification of CQA series quick lock R.F. coaxial connectors together with the proforma blank detail specification.

IEC/PAS 61169-41:2009(E) is a sectional specification. It provides information and rules for preparation of detail specification of CQA series quick lock R.F. coaxial connectors together with the pro- forma blank detail specification. It also prescribes mating face dimensions for general connectors-grade 2, dimensional detail of standard test connectors-grade 0, gauging information and tests selected from IEC 61169-1 applicable to all detail specifications relating to CQA series RF connectors. This specification indicates recommended performance characteristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levers M and H.