DD ISO/TS 10465-1:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Installation - Design considerations
   4.1 General
   4.2 Site assessment
   4.3 Flexible pipe - Technical concepts
   4.4 Pipe selection
5 On-site inspection, transportation, handling and
   storage
   5.1 Inspection
   5.2 Transportation
   5.3 Pipe handling
   5.4 Storage
   5.5 On-site inspection
6 Trench construction
   6.1 Excavation
   6.2 Minimum trench width
   6.3 Trench-bottom
   6.4 Water control
   6.5 Support of trench walls
   6.6 Trenching on slopes
   6.7 Exposing pipes when making service-line
        connections
   6.8 Trench bottom in weak soils
7 Foundation and bedding
   7.1 General
   7.2 Migration control of bedding materials
   7.3 Trench foundation
   7.4 Bedding
8 Pipe laying and jointing
   8.1 Quality assurance
   8.2 Pipe laying
   8.3 Jointing pipes laid on steep gradients
9 Embedment and backfill
   9.1 Pipe zone backfill configurations
   9.2 Embedment materials
   9.3 Placing and compacting embedment materials
   9.4 Placement of trench backfill
   9.5 Parallel or crossing piping systems
   9.6 Special precautions
10 Thrust resistance and rigid connections
   10.1 Support for control devices
   10.2 Thrust restraint
   10.3 Connections to rigid structures
   10.4 Connections with rigid joints
11 Pipe joints
   11.1 Joint characterization
   11.2 Adhesive bonded joints
   11.3 Butt and wrapped joints
   11.4 Bolted flanged joints
   11.5 Socket and spigot with elastomeric
        sealing elements
   11.6 Flexible joints with elastomeric seal
   11.7 Mechanical compression joints
   11.8 Slip-on coupling
   11.9 Mechanical band couplings
12 Special installations
   12.1 Casings
   12.2 Submarine pipelines
   12.3 Embankment installations
13 Testing
   13.1 Deflection testing
   13.2 Pressure testing
   13.3 Non-pressure pipelines
   13.4 Pressure pipelines
14 Disinfection of water mains
   14.1 Swabbing
   14.2 Disinfection
Annex A (informative) Classification of soils and
                      consolidation class terminology
Bibliography

Specifies the procedures for underground installation of flexible glass-reinforced thermosetting resin (GRP) pipes.

This part of ISO10465 describes the procedures for underground installation of flexible glass-reinforced thermosetting resin (GRP) pipes. It refers generally to GRP pipes as specified in the system standards ISO10467 and ISO10639, but it can also be used as a guide for the installation of other GRP pipes. It does not include jacking, relining or above-ground installations; nor does it cover health and safety or environmental conditions, these being addressed in national regulations at the place of installation.

NOTE The installation nomenclature, dimensions and soil moduli zones referred to in this part of ISO10465 are shown in Figure1.