DEFSTAN 00-970(PT1)SEC2/11(2014) : 2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 1: FIXED WING - SECTION 2: FLIGHT
Hardcopy , PDF
11-07-2014
English
01-01-2014
Preface
SECTION 2 - FLIGHT
2.0 Introduction and Abbreviations
2.1 General requirements and definitions
2.2 General handling flight test requirements
2.3 Ground handling
2.4 Take off and initial climb
2.5 Circuit, approach, landing and overshoot
2.6 Longitudinal trim, stability and control
2.7 Demonstration of limits of flight and manoeuvre envelopes
2.8 Lateral and directional trim, stability and control
2.9 Rapid rolling/roll coupling
2.10 Behaviour at or near the stall
2.11 Lift boundaries
2.12 Spinning
2.13 Aerobatic manoeuvres
2.14 Effect of engine failures
2.15 Effect of system failures
2.16 Automatic flight control systems and flight directors
2.17 General handling
2.18 Air to air refuelling
2.19 Handling tests specific to VSTOL aeroplanes
2.20 Handling performance in icing conditions
2.21 Longitudinal flying qualities
2.22 Lateral and directional flying qualities
2.23 Requirements for structural and equipment exposure to
noise and vibration
2.24 Stalling, post-stall gyrations and spins and miscellaneous
flying qualities
2.25 Handling requirements for VSTOL aeroplanes
SECTION 2 - TABLES
SUPPLEMENTS
Leaflet 0 to 66
Specifies requirements for Airworthiness and Design Certification for the design, development and testing of Fixed Wing Aircraft for UK Military operation.
DevelopmentNote |
Supersedes DEFSTAN 00-970(PT1)SEC2/10(2013). (02/2014)
|
DocumentType |
Standard
|
Pages |
510
|
PublisherName |
UK Ministry of Defence Standards
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
ISO 1151-8:1992 | Flight dynamics — Concepts, quantities and symbols — Part 8: Concepts and quantities used in the study of the dynamic behaviour of the aircraft |
DEFSTAN 00-35(PT5)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 5: INDUCED MECHANICAL ENVIRONMENTS |
MIL-STD-810 Revision G:2008 | ENVIRONMENTAL ENGINEERING CONSIDERATIONS AND LABORATORY TESTS |
ISO 1151-9:1993 | Flight dynamics — Concepts, quantities and symbols — Part 9: Models of atmospheric motions along the trajectory of the aircraft |
ISO 1151-1:1988 | Flight dynamics — Concepts, quantities and symbols — Part 1: Aircraft motion relative to the air |
ISO 1151-5:1987 | Flight dynamics — Concepts, quantities and symbols — Part 5: Quantities used in measurements |
ISO 1151-7:1985 | Flight dynamics — Concepts, quantities and symbols — Part 7: Flight points and flight envelopes |
DEFSTAN 00-35(PT3)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 3: ENVIRONMENTAL TEST METHODS |
ISO 1151-4:1994 | Flight dynamics — Concepts, quantities, and symbols — Part 4: Concepts and quantities used in the study of aircraft stability and control |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.