DEFSTAN 02-170/1(2000) : 2000
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
REQUIREMENTS FOR EPDM RUBBER CIRCULAR AND `D' SECTION MARINE FENDERS
12-01-2013
02-11-2015
TITLE PAGE
SCOPE
FOREWORD
Sponsorship
Conditions of Release
General
MOD Tender or Contract Process
Related Documents
Health and Safety
Warning
CONTENTS
SECTION 1 - TYPE APPROVAL
SECTION 2 - COMPOSITION
SECTION 3 - PROCEDURES FOR MIXING AND CURING EPDM RUBBER
SECTION 4 - TESTING
SECTION 5 - FENDER SELECTION REQUIREMENTS
SECTION 6 - IDENTIFICATION AND PACKAGING
ANNEX A - RELATED DOCUMENTS
ANNEX B - DEFINITIONS AND ABBREVIATIONS
ANNEX C - REQUIRED MECHANICAL PROPERTIES OF MATERIAL
ANNEX D - CIRCULAR SECTION FENDERS WITH CIRCULAR INNER BORE
D.1 - YOUNG'S MODULUS, STIFFNESS AND STORAGE ENERGY
REQUIREMENTS
ANNEX E - CIRCULAR SECTION FENDERS WITH CIRCULAR INNER BORE
E.1 - YOUNG'S MODULUS, STIFFNESS AND STORAGE ENERGY
REQUIREMENTS
ANNEX F - CIRCULAR SECTION FENDERS WITH CIRCULAR INNER BORE
F.1 - YOUNG'S MODULUS, STIFFNESS AND STORAGE ENERGY
REQUIREMENTS
ANNEX G -'D' SECTION FENDERS WITH 'D' SHAPED INNER BORE
G.1 - YOUNG'S MODULUS STIFFNESS AND STORAGE ENERGY
REQUIREMENTS
ANNEX H -'D' SECTION FENDERS WITH 'D' SHAPED INNER BORE
H.1 - YOUNG'S MODULUS, STIFFNESS AND STORAGE
ENERGY REQUIREMENTS
ANNEX I -'D' SECTION FENDERS WITH 'D' SHAPED INNER BORE
I.1 - YOUNG'S MODULUS, STIFFNESS AND STORAGE ENERGY
REQUIREMENTS
ALPHABETICAL INDEX
Deals with the requirements for a terpolymer made from ethylene propylene diene monomer (EPDM) to be used for circular and 'D' shaped section rubber fenders to be fitted to the structure of HM Surface Ships.
| DevelopmentNote |
This is a redesignation of NES 170. (01/2001) This standard is obsolescent because it is no longer required for the procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (07/2003)
|
| DocumentType |
Standard
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Withdrawn
|
| Supersedes |
| DEFSTAN 05-92/2(1995) : 1995 | QUALITY SYSTEM REQUIREMENTS FOR PRODUCTION, INSTALLATION AND SERVICING |
| BS 1673-10:1977 | Methods of test for raw rubber and unvulcanized compounded rubber. Measurement of prevulcanizing and curing characteristics by means of curemeters |
| DEFSTAN 93-31/2(1983) : 1983 AMD 1 1984 | TEST PROCEDURES AND PROCESS REQUIREMENTS FOR FULLY COMPOUNDED UNVULCANIZED RUBBER |
| NES 724 : ISSUE 2 AMD 4 | PACKAGING |
| DEFSTAN 81-41(PT1)/5(2003) : 2003 | PACKAGING OF DEFENCE MATERIAL - PART 1: INTRODUCTION TO DEFENCE PACKAGING REQUIREMENTS |